Goldture Tech Limited
Add to Cart
Resin Filled RGB Swimming Pool Light 42W AC12V IP68 Waterproof
| Material | Plastic |
| Power | 18W/ 24W/ 30W/ 35W/ 42W |
| Light source | SMD 2835 LED |
| Voltage | AC 12V |
| Size | D250xH40mm |
| Color | Warm white/ Cold white/ Blue/ RGB |
| Waterproof | IP68 |
| Control Way | Switch on/ off |
| Beam angle | 120 degree |
| Weight | 0.7kg |
| Led chip | Epistar |
| Cable | 1.5 meter |
Characteristic
1. The light source and shell of this swimming pool lamp can be separated. When customers want to change other wattage or other color light sources, they can be separated and then assembled together.
2. It can only work at the voltage of AC12V. The customer needs to connect a transformer to convert other voltages into AC12V, and it cannot be DC12V.
3. RGB is mixed color. It is composed of red, blue, green, cyan, white, purple and some dynamic modes. However, it does not have a remote control. Customers can control the color change of the lamp by cutting off power.
4. This lamp is only applicable to the concrete swimming pool, not the liner film pool.
Installation
All lamps should be placed on the wall of the pool at approximately 700mm below the water surface, in areas that are easily accessible from the upper edge of the pool.
1. It is highly recommended to use the underwater cable gland
2. All lamps should be installed on the same transformer and switch.
3. The lamp is supplied with cable of 1.5 meter according to the need of the user, making it possible to install multiple lamps connected to a single junction box.
Dissemble the bracket from the back of the lamp. Place the bracket over the desired location, mark the holes, drill the holes, insert the roll plugs, and fasten the bracket on the pool wall using the stainless steel screws provided. Wind the cable behind the lamp, and then fasten the lamp on the bracket.
